Siemens HiPath 5000 Service Manual page 306

boards.fm
Boards for HiPath 3000
Peripheral Boards
Connecting ISDN (S
You can use the MW jacks on the STLS boards to connect between one and four ISDN S
es. The interfaces on the STLS boards are freely configurable.
EURO CO point-to-point
●
EURO CO point-to-multipoint
●
EURO bus
●
CorNet N/CorNet NQ slave
●
Using HiPath 3000 Manager E, you can also set up configurations for networking and ded-
●
icated lines
Use the S interface S
0
You can also connect S
telephone, group 4 fax device, PC, dialing aid) via an S
The connection (networking) to HiPath 3000 and HiPath 4000 (CorNet NQ) can also be set up
via S interfaces S
0 0
S connection options:
0
Point-to-point (PP) (default)
●
Point-to-multipoint (PMP)
●
Connecting an ISDN trunk (not for U.S.)
Insert the connection cable supplied in jacks S
carrier.
Networking connection (HiPath 4000/CorNet NQ (not for U.S.)
Insert the connection cable supplied in jacks S
4000 port.
3-216
) interfaces (not for U.S.)
0
1 for connection to the public telecommunications network (ISDN trunk).
0
interfaces S 2 to S
0 0
1 to S 4.
0
4 to the ISDN trunk or to ISDN terminals (ISDN
0
bus.
0
1 to S 4. Insert the other end in the NT of the
0 0
1 to S 4. Connect the other end with the HiPath
0 0
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
P31003-H3560-S403-54-7620, 09/05
bus-
0