Table of Contents
Advertisement
Serial Peripheral Interface Module (SPI)
16.6.3 Transmission Format When CPHA = 1
SPSCK CYCLE #
FOR REFERENCE
SPSCK; CPOL = 0
SPSCK; CPOL =1
MOSI
FROM MASTER
MISO
FROM SLAVE
;
SS
TO SLAVE
CAPTURE STROBE
Technical Data
288
Figure 16-6
shows an SPI transmission in which CPHA is logic 1. The
figure should not be used as a replacement for data sheet parametric
information. Two waveforms are shown for SPSCK: one for CPOL = 0
and another for CPOL = 1. The diagram may be interpreted as a master
or slave timing diagram since the serial clock (SPSCK), master in/slave
out (MISO), and master out/slave in (MOSI) pins are directly connected
between the master and the slave. The MISO signal is the output from
the slave, and the MOSI signal is the output from the master. The SS line
is the slave select input to the slave. The slave SPI drives its MISO
output only when its slave select input (SS) is at logic 0, so that only the
selected slave drives to the master. The SS pin of the master is not
shown but is assumed to be inactive. The SS pin of the master must be
high or must be reconfigured as general-purpose I/O not affecting the
SPI. (See
16.8.2 Mode Fault
begins driving its MOSI pin on the first SPSCK edge. Therefore, the
slave uses the first SPSCK edge as a start transmission signal. The SS
pin can remain low between transmissions. This format may be
preferable in systems having only one master and only one slave driving
the MISO data line.
1
2
MSB
BIT 6
BIT 5
MSB
BIT 6
BIT 5
Figure 16-6. Transmission Format (CPHA = 1)
Serial Peripheral Interface Module (SPI)
Error.) When CPHA = 1, the master
3
4
5
6
BIT 4
BIT 3
BIT 2
BIT 4
BIT 3
BIT 2
7
8
BIT 1
LSB
BIT 1
LSB
MC68HC908AB32
Rev. 1.0
—
MOTOROLA
Advertisement
Table of Contents
