Table of Contents
Advertisement
MC68HC908AB32
Rev. 1.0
—
MOTOROLA
M — Mode (Character Length) Bit
This read/write bit determines whether SCI characters are eight or
nine bits long.
(See Table
stop bit, as a receiver wakeup signal, or as a parity bit. Reset clears
the M bit.
1 = 9-bit SCI characters
0 = 8-bit SCI characters
WAKE — Wakeup Condition Bit
This read/write bit determines which condition wakes up the SCI: a
logic 1 (address mark) in the most significant bit position of a received
character or an idle condition on the PTE1/RxD pin. Reset clears the
WAKE bit.
1 = Address mark wakeup
0 = Idle line wakeup
ILTY — Idle Line Type Bit
This read/write bit determines when the SCI starts counting logic 1s
as idle character bits. The counting begins either after the start bit or
after the stop bit. If the count begins after the start bit, then a string of
logic 1s preceding the stop bit may cause false recognition of an idle
character. Beginning the count after the stop bit avoids false idle
character recognition, but requires properly synchronized
transmissions. Reset clears the ILTY bit.
1 = Idle character bit count begins after stop bit
0 = Idle character bit count begins after start bit
PEN — Parity Enable Bit
This read/write bit enables the SCI parity function. (See
When enabled, the parity function inserts a parity bit in the most
significant bit position. (See
1 = Parity function enabled
0 = Parity function disabled
Serial Communications Interface Module (SCI)
Serial Communications Interface Module (SCI)
15-5.) The ninth bit can serve as an extra
Figure
15-3.) Reset clears the PEN bit.
I/O Registers
Table
15-5.)
Technical Data
263
Advertisement
Table of Contents
