Choosing A Filter Capacitor - Motorola MC68HC908AB32 Technical Data Manual

Hcmos microcontroller unit
Table of Contents

Advertisement

Clock Generator Module (CGM)

9.10.3 Choosing a Filter Capacitor

Technical Data
154
Also important is the operating voltage potential applied to V
power supply potential alters the characteristics of the PLL. A fixed value
is best. Variable supplies, such as batteries, are acceptable if they vary
within a known range at very slow speeds. Noise on the power supply is
not acceptable, because it causes small frequency errors which
continually change the acquisition time of the PLL.
Temperature and processing also can affect acquisition time because
the electrical characteristics of the PLL change. The part operates as
specified as long as these influences stay within the specified limits.
External factors, however, can cause drastic changes in the operation of
the PLL. These factors include noise injected into the PLL through the
filter capacitor, filter capacitor leakage, stray impedances on the circuit
board, and even humidity or circuit board contamination.
As described in
9.10.2 Parametric Influences On Reaction
external filter capacitor C
the PLL. The PLL is also dependent on reference frequency and supply
voltage. The value of the capacitor must, therefore, be chosen with
supply potential and reference frequency in mind. For proper operation,
the external filter capacitor must be chosen according to the following
equation:
For the value of V
, the voltage potential at which the MCU is
DDA
operating should be used. If the power supply is variable, choose a value
near the middle of the range of possible supply values.
This equation does not always yield a commonly available capacitor
size, so round to the nearest available size. If the value is between two
different sizes, choose the higher value for better stability. Choosing the
lower size may seem attractive for acquisition time improvement, but the
PLL may become unstable. Also, always choose a capacitor with a tight
tolerance (±20% or better) and low dissipation.
Clock Generator Module (CGM)
is critical to the stability and reaction time of
F
V
DDA
C
=
C
------------ -
F
FACT
f
RDV
MC68HC908AB32
. The
DDA
Time, the
Rev. 1.0
MOTOROLA

Advertisement

Table of Contents
loading

Table of Contents