Figure 10-1: 4285/4286 Vip Module Connections - ADEMCO VISTA-128B Installation And Setup Gude

SPEAKER NOTE: IF CONNECTING SINGLE SPEAKER, USE 8-ohm SPEAKER ONLY.
IF CONNECTING 2 SPEAKERS, USE 4-ohm or 8-ohm SPEAKERS
AND CONNECT IN SERIES.
4286 VIP MODULE
NOTE:
4286 DEVICE
ADDRESS IS
FACTORY SET
TO "4"
NO
CONNECTION
YELLOW GREEN
4500
THERMOSTAT
IMPORTANT NOTE FOR EXISTING INSTALLATIONS:
EXISTING WIRES CONNECTED TO THE "HANDSET"
TERMINALS ON CONTROL MUST BE MOVED FROM
THERE TO TERMINALS 3 AND 4 ON THE 4286.
U.S. PATENT No. 4791658

Figure 10-1: 4285/4286 VIP Module Connections

Use an RJ31X Jack with the phone cable supplied with the control. Use an additional RJ31X
Jack and a direct-connect cord to make connections to the 4285/4286. Make all connections
exactly as shown in Figure 10-1. This is essential, even if the system is not connected to a
central station. The 4285/4286 will not function if this is not done. If the leads on the
cable are too short to reach their assigned terminals, splice additional wires to them, as
required.
If Touch-tones are not present following phone access to the security system via an on-
premises phone, try reversing the pair of wires connected to terminals 3 and 4 on the
4285/4286.
If the phone plug is disconnected from the control, the premise's phones will not operate.
LOUDER
SPEAKER
VOLUME
CONTROL
CALLER ID
UNIT
KEYED
HEADER
TO CONTROL PANEL
KEYPAD CONNECTIONS
YELLOW
NO CONNECTION
RED
BLACK
GREEN
Section 10 – 4285/4286 VIP Module
SEE SPEAKER NOTE
GREY
BROWN
EARTH
GROUND
TIP RING TIP RING
HANDSET INCOMING
TELCO LINE
THIS DEVICE COMPLIES WITH FCC RULES, PART 68
FCC REGISTRATION No. AC3USA-74659-KX-N
RINGER EQUIVALENCE: 1.0B
INCOMING TELCO LINE
TIP
RJ31X
RING
PREMISES
JACK
ANSWERING
MACHINE AND
PHONES
ANSWERING
MACHINE
10-3