ADEMCO VISTA-128B Installation And Setup Gude page 148

VISTA-128B Installation and Setup Guide
After entering Scheduling Menu Mode, press 0 until the "Timed Events ?" prompt appears.
Timed Events ?
1 Yes
TIMED EVENT # ?
01-20, 00=Quit 01
01 ACTION ?
none
Action Codes:
01=Relay On
02=Relay Off
03=Relay Close for 2 seconds
04=Relay Close XX minutes
05=Relay Close YY seconds
06=Relay Group On
07=Relay Group Off
08=Relay Group Close for 2 seconds
09=Relay Group Close XX minutes
10=Relay Group Close YY seconds
Action Codes:
20=Arm-STAY
21=Arm AWAY
22=Disarm
23=Force Arm STAY
24=Force Arm AWAY
40=Enable Open Window by part.
41=Enable Close Window by part.
24-14
Enter 1 to program timed events.
0 = No 0
Enter the timed event number to be programmed (01-20).
Press [∗].
The system will then prompt the user to enter the desired
action to be taken.
Enter 00 at the "TIMED EVENT #?" prompt to quit the timed
event menus and display the "Quit ?" prompt.
Enter the action code for this timed-event number from the list
at the left. This could be an output command, an arming
00
command, or any other time-driven event.
Press [∗]to accept the entry. The prompt for the action specifier
will display.
Actions 01-05
If actions 01-05 were selected, the
prompt at the right will be
displayed. Enter the relay number.
Press [∗] to accept entry. The "Time
Window ?" prompt appears.
Actions 06-10
If actions 06-10 were selected, the
prompt at the right will be
displayed. Enter the relay group
number.
Press [∗] to accept entry. The "Time
Window ?" prompt appears.
Actions 21-24 and 40-41
If actions 21-24 or 40-41 were
selected, the prompt at the right
will be displayed. Enter the
partition to which the action
applies. Enter 0 to select all
partitions. Enter a partition number
again to deselect it.
Press [∗] to accept entry. The "Time
Window ?" prompt appears.
Action Specifier:
01 RELAY # ?
00
01 RELAY GRP # ?
00
PART? 12345678
HIT 0-8 X X