ADEMCO VISTA-128B Installation And Setup Gude page 149

Action Codes:
30=Auto bypass - Zone list
31=Auto unbypass - Zone list
42=Enable Access Window for
Access group(s)
50=Off-normal Reminder
01 Time Window ?
00:00 00:00 01
01 Active time ?
0
Days ? MTWTFSSH
Hit 0-8 x x
Quit ?
1 = YES 0 = NO 0
Actions 30-31
If actions 30-31 were selected, the
prompt at the right will be
displayed. Enter the zone list
number that contains the zones to
be bypassed or unbypassed.
Press [∗] to accept entry. The "Time
Window ?" prompt appears.
Action 42
If action 42 was selected, the
prompt at the right will be
displayed. Enter the group number
to which the time window will
apply.
Press [∗] to accept entry. The "Time
Window ?" prompt appears.
Action 50
No action specifier is required for
this action since the conditions that
this will occur for are system-wide.
Enter the time window number (01-20) for which this timed
event is to occur. As the number is keyed in, the actual time
that has been stored for the time window number will be
displayed.
Press [∗] to accept entry.
Enter the activation time from 1-4 (listed below). As the
number is keyed in, the activation time will be displayed. The
choices are:
1: Trigger at the start of the window.
2: Trigger at the end of the window.
3: Take effect only for the duration of the window.
4: Trigger at both the start and the end of the window.
Example: - coffee break buzzer.
Press [∗] to accept entry.
The system will then ask for which days the event is to be
activated.
Press 0 to toggle all days on or off; or else press keys 1-8 to
toggle the letter "x" under the day on or off (Monday = 1,
Holiday = H = 8).
When all entries have been made, the "TIMED EVENT #?"
prompt is displayed again.
Repeat the procedure for each timed event required for the
installation.
Enter 0 at the "Quit ?" prompt to return to the main menu
choices and continue programming. Enter 1 to quit Scheduling
Section 24 – Scheduling Options
Action Specifier:
01 ZONE LIST ?
ENTER 01-15
GROUP ? 12345678
HIT 0-8 X
01
24-15