Installing The 5800Tm Module; House Id Sniffer Mode - ADEMCO VISTA-128B Installation And Setup Gude

VISTA-128B Installation and Setup Guide

Installing the 5800TM Module

Installation of this module is necessary only if you are using one or more 5827BD Wireless
Bi-directional keypads.
The 5800TM must be located next to the 5881 Receiver (between one and two feet from the
receiver's antennas). The 5800TM must not be installed within the control cabinet. Mount the
unit using its accompanying mounting bracket.
Wiring the 5800TM
To wire the 5800TM,perform the following steps:
Step
1
2
3
4
The address setting must be enabled in the control's Device Programming in the #93 Menu Mode
as a keypad and then assigned to a partition.

House ID Sniffer Mode

This mode applies only if you are using a wireless keypad (5827/5827BD). Use the House ID
Sniffer Mode to make sure you do not choose a House ID that is in use in a nearby system.
To enter this mode, perform the following steps:
Step
1
2
3
4
Since Sniffer Mode effectively disables RF point reception, Sniffer Mode cannot be entered while
any partition is armed.
8-4
Action
Mount the 5800TM within 2 feet of the 5881 RF Receiver.
Connect the 5800TM to the control panel's keypad connection terminals, using
the supplied connector with flying leads, as follows:
WIRE
RED (+12VDC)
BLACK (Ground)
GREEN (Data to Control)
YELLOW (Data from Control)
BLUE: Not Used
Cut the red jumper for Address Setting 28; cut the white jumper for Address 29;
cut both jumpers for Address 30.
For additional information, refer to the 5800TM's instructions.
Action
Enter your [Installer Code] + [#] + [2].
The receiver will now "sniff" out any House IDs in the area and display them.
Keep the receiver in this mode for about 2 hours to give a good indication of the
House IDs being used. Use a House ID that is not displayed.
To exit the Sniffer Mode, simply enter your [Installer Code] + OFF.
If you need to re-program the House ID of the receiver, do so before proceeding.
TERMINAL ON CONTROL
Terminal 6
Terminal 7
Terminal 8
Terminal 9