Mounting The Vip Module; Wiring The Vip Module - ADEMCO VISTA-128B Installation And Setup Gude

VISTA-128B Installation and Setup Guide

Mounting the VIP Module

The VIP Module may be mounted in the control cabinet if space is available or, if this is not
possible, on the side of the cabinet or adjacent to it. Pry off the VIP Module's cover prior to
wiring.
Do not mount the VIP Module on the cabinet door or attempt to attach it to the PC board.
To mount the VIP module, perform the following steps:
Step
1
2
3

Wiring the VIP Module

The 4285/4286 is wired between the control panel and the premises' handset(s). It listens for
TouchTones on the phone line and reports them to the control panel. During on-premises
phone access, it powers the premises phones; during off-premises phone access, it seizes the
line from the premises phones and any answering machines.
To wire the VIP module, perform the following steps:
Step
1
2
3
10-2
Action
If you are mounting the VIP module inside the control cabinet, attach it to the
cabinet's interior surface with 2-faced adhesive tape. You may leave the module's
cover off.
If you are mounting the VIP module outside the control cabinet, use the screw
holes at the rear to mount horizontally or vertically (2-faced adhesive tape may be
used, if preferred). You can bring wires out from the side or back (a round
breakout is also available on the back). When you complete the Module's
mounting and wiring, you should install the module's cover (with label affixed, as
indicated next).
Affix the 4285/4286 connections label (supplied separately) to the inside of the VIP
Module's cover if the cover is used. Otherwise, affix the label to the inside of the
control cabinet's door.
Action
Make 12V (+) and (–) and data-in and data-out connections from the VIP Module
to the control, using the connector cable supplied with the VIP Module see figure
10-1. These are the same connections as for remote keypads.
Insert the keyed connector into the mating header on the VIP Module.
Connect terminals 1 through 7 on the VIP Module as shown in the table below.
4285/4286 Terminal
1. Phone In (Tip)
2. Phone In (Ring)
3. Phone Out (Tip)
4. Phone Out (Ring)
5. No Connection
6. Audio Out 1∗
7. Audio Out 1∗
∗
Supported by the 4286 only
Connects to:
green wire of direct connect cord
red wire of direct connect cord
brown wire of direct connect cord
gray wire of direct connect cord
Speaker
Speaker