Section 10. 4285/4286 Vip Module; General Information; Mounting The Vip Module - ADEMCO VISTA-100 Isntallation Instructions And Programming Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section

General Information

Mounting the VIP Module

Wiring the VIP Module
Programming the VIP Module
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
The 4285/4286 VIP Module is not permissible for Commercial Fire or UL Commercial Burglary
U L
installations.
General Information
The 4285/4286 VIP Module is an add-on accessory that allows the user to access the security
system (and relays) via a TouchTone telephone, either from the premises or by calling the
premises from a remote location. Only one VIP Module can be used in a security system.
You must enable this module in the #93 Device Programming Mode as Device Address 4,
and assign it to a partition.
The 4285/4286 VIP Module offers the following features:
• Allows the user to receive synthesized voice messages over the phone regarding the
status of the security system.
• Allows the user to arm and disarm the security system and perform most other
commands using the telephone keypad.
• Allows the user to control relays using the telephone keypad.
• Provides voice annunciation over the phone to confirm any command that is entered.
• Announces many of the same words that would normally be displayed on an alpha
keypad under the same system conditions. Refer to the words in bold on the Alpha
Vocabulary list found in Section 22: #93 Menu Mode Programming.
• Can be supervised for connection to control panel (annunciated and reported as zone
804).
Detailed operating instructions for phone access to the security system are provided with the VIP
Module. In addition, a Phone Access User's Guide is supplied with the VIP Module for the user
of the system.
Mounting the VIP Module
The VIP Module may be mounted in the control cabinet if space is available or, if not,
mounted on the side of the cabinet or adjacent to it. Pry off the VIP Module's cover before
wiring.
4285/4286 VIP Module
S E C T I O N 1 0
10-1