Zone Type Definitions; Zone Number Designations - ADEMCO VISTA-128B Installation And Setup Gude

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section

Zone Number Designations

Zone Type Definitions

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Zone Number Designations
The VISTA-128B supports up to 128 zones of hardwire, polling loop and/or wireless
protection, distributed among up to 8 partitions. The following table lists the zone numbers
and the types of sensors that can be used with each in this system, and some alternate
functions the zones may be used as:
Zone
1
5
7
8
1-9
9
1-128
10-128
995
996
999
Zone Type Definitions
Each zone must be assigned a zone type, which defines the way in which the system responds
to faults in that zone. In addition, there are three keypad-activated zones (panic keys; see
note) for each partition, a polling loop supervision zone, and four RF supervisory zones, two
for each RF receiver installed. Zone types are defined below.
Type 00: Zone Not Used
Program a zone with this zone type if the zone is not used.
Type 01: Entry/Exit #1 Burglary
Provides entry delay whenever the zone is faulted and the system is armed in the AWAY or
STAY mode. When the panel is armed in the INSTANT or MAXIMUM mode, no entry delay
is provided. Exit delay begins whenever the control is armed, regardless of the arming mode
selected. These delays are programmable.
Assign this zone type to zones that are used for the primary entry and exit of the facility.
Sensors
2-wire Smoke Detectors (if used)
Audio Alarm Verification (if used)
Keyswitch (if used)
Latching-Type Glassbreak Detectors (if used)
Traditional Hardwired Zones
Programmable for Fast Response
5800 Series Wireless Devices
Polling Loop Devices
+ 1 Panic
# + 3 Panic
+ # Panic
Zone Type Definitions
S E C T I O N 2 0
20-1