#93 Menu Mode Programming - ADEMCO VISTA-128B Installation And Setup Gude

VISTA-128B Installation and Setup Guide

#93 Menu Mode Programming

The #93 Menu Mode is a mode through which much of the system's programming is done. It
offers main menu selections for the following:
•
Zone Programming
•
Expert Mode Programming
•
Report Code Programming
•
Alpha Programming
•
Device Programming
•
Output Programming
•
Relay Voice Descriptors
•
Custom Index Programming (VIP Module substitute words)
•
Access Point Programming (used for VistaKey modules)
•
Access Group Programming (used for VistaKey modules)
•
Event/Action Programming (used for VistaKey modules)
Press 0 (NO) or 1 (YES) in response to the displayed menu selection. Pressing 0 will display
the next choice in sequence. The keypad will then prompt you with questions regarding the
programming of a particular zone or device. (Refer to the individual sections to program
each option shown.)
The following is a list of commands used while in the Menu Mode.
#93 Menu Mode Key Commands
00+ [ ]
19-4
PROGRAMMING PARTITION-SPECIFIC FIELDS
Enter the partition to be programmed.
Enter a partition-specific field # and make entry.
After partition-specific fields are programmed,
Enter any global field number to return to the global fields at any time.
#93 Enters Menu Mode.
Serves as ENTER key. Press to have keypad accept entry.
[ ]
[#] Backs up to previous screen.
0 Press to answer NO.
1 Press to answer YES.
Escapes from Menu Mode, back into Data Field Programming Mode,
if entered at the first prompt of each main menu option.
Press *91 to select a partition.
↓
↓
↓
press *91 to select next partition.