Keypad Functions; General Information; Arming Commands - ADEMCO VISTA-128B Installation And Setup Gude

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section

General Information

Arming Commands

Access Control
Delaying Closing Time
Partition "Go To" Command
Viewing Capabilities of a User
Viewing Zone Descriptors
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
General Information
The keypad allows the user to arm and disarm the system, and perform other system
functions, such as bypassing zones, viewing messages from the central station, and
displaying zone descriptors. The system conditions are shown in the display window.
When an alarm occurs, keypad sounding and external sounding will occur, and the zone(s) in
alarm will be displayed on the keypad. Disarming the system (enter the security code and
press the OFF key) will silence both keypad and external sounders. After the system is
disarmed, the system displays any zones that were in an alarm condition during the armed
period. To clear this display, simply repeat the disarm sequence.
The keypads also feature chime annunciation, and 3 panic keys (for silent, audible, fire or
personal emergency alarms) which can notify the central station of an alarm condition, if
that service is connected.
Arming Commands
The following is a brief list of arming commands. For detailed information concerning these
functions, refer to the User's Manual.
Display Faulted
Zones
Arming Away
Arming Stay
Arming Instant
Arming Maximum
Disarming
Quick Arming
Viewing Downloaded Messages
Using the Built-in User's Guide
Panic Keys
Speed Key [D] (Macros)
Manual Relay Activation Mode (#70 Mode)
Instant Activation Mode (#77 Mode)
To arm the system must be in the READY condition (all zones
must be intact). If the "NOT READY" message appears, press the
READY * key to display faulted zones.
Enter code + 2 (AWAY)
Enter code + 3 (STAY) (all zones designated as zone types 4 and 10
will be automatically bypassed).
Enter code + 7 (INSTANT) (same as STAY without entry delay).
Enter code + 4 (MAXIMUM) (same as AWAY without entry delay).
Enter code + 1 (OFF).
Note that if QUICK ARM is enabled (field *29), the # key can be
pressed instead of entering the security code, for any of the arming
procedures (Away, Stay, Instant, Maximum, etc.).
S E C T I O N

Keypad Functions

2 9
29-1