Scheduling Menu Mode - ADEMCO VISTA-128B Installation And Setup Gude

VISTA-128B Installation and Setup Guide

Scheduling Menu Mode

The #80 Scheduling Menu Mode is used to program most of the scheduling and timed-event
options. To enter this mode, the system must first be in the normal operating mode (all
partitions disarmed). Enter [User Code] + [#] + 8 + 0. NOTE: Only users with an Installer
or Master level user code may enter the #80 mode.
The following can be programmed while in this mode:
• Define time windows
• Assign open/close schedules to each partition
• Assign holiday schedules
• Program time-driven events (for system functions and relay activation)
• Assign limitation of access schedules
Some scheduling features are programmed in Data Field Programming Mode ([Installer
Code] + 8 0 0 0). The general Programming Mode scheduling fields are listed below.
System-Wide Fields:
Partition-Specific fields:
Report Code Programming in #93 Menu Mode
Event-driven relay activation options are programmed using the Output Programming in the
#93 Menu Mode. These actions are in response to a programmed action. However, relay
activation can also be time-driven, and thus be used to initiate a desired action. Time-driven
relay activation options are programmed using the #80 Menu Mode. Refer to the Time-
Driven Event Programming for procedures.
Steps To Programming Scheduling Options
This section contains examples of the worksheets only. For complete worksheets, see the
Programming Guide accompanying this Installation and Setup Guide.
In order to use #80 Scheduling Menu Mode, use the worksheets to do the following:
•
Define time windows (up to 20)
•
Define the daily open/close schedules (one schedule per day, per partition)
•
Define the holidays to be used by the system (up to 16)
•
Define limitation of access times (up to 8 schedules)
•
Define the time-driven events (up to 20)
Note: Temporary schedules are programmed using the #81 Menu Mode.
Use #80 Scheduling Menu Mode to perform the following functions:
•
Program the time windows
•
Program the open/close schedules
•
Program the time-driven events
•
Program the access schedules
24-6
1*74 -1*75 Relay time-out values
2*01-2*02
2*11
1*76
2*05
2*06
2*07
2*08
2*09
2*10
(System Group #3)
Daylight savings time options
Allow disarming outside window if alarm occurs
Access control relay for this partition
Auto-arm delay value
Auto-arm warning time
Auto-disarm delay value
Force-arm enable
Open/Close Reporting by Exception
Restrict disarm only during windows
Scheduling related report codes