Section 10 - 4285/4286 Vip Module; General Information - ADEMCO VISTA-32FB Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section

General Information

Mounting the VIP Module
Wiring the VIP Module
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
The 4285/4286 VIP Module is not permissible in commercial fire or UL commercial burglary
U L
installations.
General Information
The 4285/4286 VIP Module is an add-on accessory that permits the user to access the
security system (and relays) via a Touch-tone telephone, either from the premises or by
calling the premises from a remote location. Only one VIP Module can be used in a security
system. This module must be enabled as Device Address 4 in Device Programming in #93
Menu Mode Programming section of the Quick Start Guide, and must be assigned to a
partition.
The 4285/4286 VIP Module offers the following features:
•
Allows the user to receive synthesized voice messages over the phone regarding the
status of the security system.
•
Allows the user to arm and disarm the security system and perform most other
commands using the telephone keypad.
•
Allows the user to control relays using the telephone keypad.
•
Provides voice annunciation over the phone to confirm any command that is entered.
•
Announces many of the same words that would normally be displayed on an alpha
keypad under the same system conditions. Refer to the words in bold on the Alpha
Vocabulary list found in #93 Menu Mode Programming section of the Quick Start Guide.
•
Can be supervised for connection to control panel (annunciated and reported as zone
804).
Detailed operating instructions for phone access to the security system are provided with the VIP
Module. In addition, a Phone Access User's Guide is supplied with the VIP Module for the user
of the system.
4285/4286 VIP Module
S E C T I O N 1 0
10–1