Scheduling Menu Structure - ADEMCO VISTA-128B Installation And Setup Gude

Scheduling Menu Structure

To program schedules, enter Scheduling Program Mode:
[User Code] + [#] + 80. (Installer or Master level user code.)
This mode can only be entered when all partitions are disarmed.
There are 5 sections of scheduling menus, as shown below. Entering 1 at a displayed main
menu prompt will select that menu section. Prompts for programming that scheduling
feature will then appear. Enter 0 to skip a section and display the next menu option.
Time Window ?
1 Yes
O/C Schedules ?
1 Yes
Holidays ?
1 Yes
Timed Events ?
1 Yes
Access Sched. ?
1 Yes
Quit ?
1 Yes
Upon entering Schedule Menu Mode, this prompt will appear.
Enter 1 to program time windows. Refer to Time Windows
0 = No 0
Programming later in this section for detailed procedures.
Enter 0 to move to the "O/C Schedules?" prompt.
Enter 1 to program opening and closing schedules. Refer to
Open/Close Schedules Programming later in this section for
0 = No 0
detailed procedures.
Enter 0 to move to the "Holidays?" prompt.
Enter 1 to program holiday schedules. Refer to Holiday
Schedule Programming later in this section for detailed
0 = No 0
procedures.
Enter 0 to move to the "Timed Events?" prompt.
Enter 1 to program timed events for relay outputs, additional
schedules, and other system functions. Refer to Time Driven
0 = No 0
Event Programming later in this section for detailed
procedures.
Enter 0 to move to the "Access Sched?" prompt.
Enter 1 to program access schedules. Refer to Limitation of
Access Schedules Programming later in this section for detailed
0 = No 0
procedures.
Enter 0 to move to the "Quit?" prompt.
Enter 1 to quit #80 Scheduling Menu Mode and return to
normal operating mode.
0 = No 0
Enter 0 to make any changes or review the scheduling
programming options. If 0 is pressed, the "Time Window?"
prompt is displayed.
Section 24 – Scheduling Options
24-7