#93 Menu Mode Programming; General Information; In This Section - ADEMCO VISTA-128B Installation And Setup Gude

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

In This Section

General Information

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
General Information
The #93 Menu Mode is a mode through which much of the system's programming is done. It
enables the programming of the system via interactive screen prompts.
After programming all system related programming fields in the usual way, press #93 while
still in programming mode to display the first choice of the menu driven programming
functions. Press 0 (NO) or 1 (YES) in response to the displayed menu selection. Pressing 0
will display the next choice in sequence.
NOTE: The following field should be preset before beginning: 2*00 Number of
Partitions. In addition, receivers should be programmed via Device programming.
Below is a list of the main menu selections. For the detailed selections refer to the VISTA-
128B Programming Guide.
Menu selections are as follows:
ZONE PROG?
1 = YES
EXPERT MODE?
1 = YES
REPORT CODE PROG?
1 = YES
ALPHA PROG?
1 = YES

#93 Menu Mode Programming

For programming the following:
•
Zone Number
0 = NO
•
Zone Response Type
•
Partition Number for Zone
•
Dialer report code for zone
•
Input Device Type for zone (whether RF, polling loop, etc.)
•
Enrolling serial numbers of 5800 Series transmitters & serial polling
loop devices into the system.
Same as Zone Programming except:
•
Done with a minimum number of keystrokes.
0 = NO
•
Can program wireless keys using pre-defined templates.
For programming the following:
•
Alarm report codes for zones
0 = NO
•
Restore & supervisory codes
•
All other system report codes
For entering alpha descriptors for the following:
•
Zone Descriptors
0 = NO
•
Installer's Message
•
Custom Words
•
Partition Descriptors
•
Relay Descriptors
S E C T I O N 2 3
23-1