ADEMCO VISTA-128B Installation And Setup Gude page 119

*37 DOWNLOAD COMMAND ENABLES
Dialer System
Shutdown Shutdown
Each of the various remote functions can either be enabled or disabled through Compass
downloading software. Disabling a function means that you will not be able to perform
that function from Compass. Default values = [11011111].
Enter 1 to enable a function, enter 0 to disable. See field 1*53 to disable the download
callback option. For UL commercial burglary installations, all entries must be 0.
*38 PREVENT ZONE XXX BYPASS (partition-specific)
Entering a zone number (001-128) prevents that zone from being bypassed by the user.
Enter 000 if this feature is not desired (all zones can be bypassed).
*39 ENABLE OPEN/CLOSE REPORT FOR INSTALLER CODE(partition-specific)
Enter 1 if Open/Close reporting for the installer is desired.
Otherwise enter 0.
*40 OPEN/CLOSE REPORTING FOR KEYSWITCH
Enter 1 to enable Open/Close reporting for the keyswitch.
Enter 0 if reporting is not desired.
*41 NORMALLY CLOSED OR EOLR (ZONES 2-8)
Enter 0 if end-of-line resistors are to be used.
Enter 1 if end-of-line resistors are not to be used, in which case only normally closed
devices must be used.
Must be 0 for UL installations.
*42 DIAL TONE PAUSE
This field sets the time the system will wait for dial tone before dialing. Applies if true
dial tone is not selected in field *43.
Enter the desired wait time for dial tone detection as follows: Enter single digit: 0 = 5
seconds; 1 = 11 seconds; or 2 = 30 seconds. Must be 0 for UL installations.
*43 DIAL TONE DETECTION
Determines whether the control will wait for a true dial tone before dialing, or if it will
wait for a predetermined delay before dialing (delay is programmed in Dial Tone Pause
field *42). The latter may be necessary in high-noise environment telco networks where
noise can be confused with dial tone, resulting in premature dialing.
Enter 1 for true dial tone wait. If no dial tone is detected, will dial at end of pause
programmed in field *42.
Enter 0 to pause for seconds entered in field *42, then dial.
Not Remote Remote
Used Bypass Disarm
Section 22 – Data Field Descriptions
Remote Upload
Arm Program
[000]
Download
Program
| |
[1]
[0]
[0]
[0]
[1]
22-5