ADEMCO VISTA-128B Installation And Setup Gude page 174

VISTA-128B Installation and Setup Guide
A user code other than the Installer Code must be programmed into the system in order for the
Quick Arm feature to work.
Mode
AWAY
STAY
INSTANT
MAXIMUM
Global Arming
If enabled for the user, the keypad will display the following:
ARM ALL
0 = NO , 1 = YES
Notes:
•
When using the Global Arm feature, if there are faults in any of the selected partitions,
the system will enter a Summary Mode in which the faulted zones of all of the selected
partitions will be displayed. These faults must be corrected or bypassed (code + BYPASS
+ [#] will attempt to bypass the faults in all of the selected partitions). This Summary
Mode will end in approximately 120 seconds if no keys are pressed.
•
If you are disarming the system using a Global Disarm, any of the selected partitions has
a condition which would cause the keypad to beep (such as alarm memory or a trouble
condition) the system enters a Summary Mode whereby the alarm memory or trouble
conditions of all of the selected partitions is displayed. This mode continues until either
approximately 120 seconds elapses or a second disarm occurs which clears the beeping.
Bypassing and Chime Mode Commands
Bypassing Zones
Chime Mode
29-2
SUMMARY OF ARMING MODES
Exit Delay
Yes
Yes
Yes
Yes
If NO, the keypad prompts for arming each partition individually.
?
If YES, the system attempts to arm all partitions allowed by this
user. If there are any faults (open doors, windows, etc.) the keypad
will display them. See notes below. These faults must be corrected
or the zone bypassed before arming will occur. When faults are
corrected, repeat the arming procedure.
Enter code + 6 (BYPASS) + 3-digit zone number. To
automatically bypass all faulted zones, use "Quick Bypass"
method: Enter code + BYPASS + #.
Enter code + 9 (CHIME). To turn Chime Mode off, enter code +
CHIME again.
Features for Each Arming Mode
Entry Delay Perimeter Armed
Yes Yes
Yes Yes
No Yes
No Yes
Interior Armed
Yes
No
No
Yes