Installation And Setup Of The 5881 Rf Receivers; Figure 8-1. 5881 Rf Receiver (Cover Removed) - ADEMCO VISTA-128B Installation And Setup Gude

Installation and Setup of the 5881 RF Receivers

To install and setup the 5881 RF Receiver, see to figure 8-1 and perform the following steps:
Step
2
3
4
CIRCUIT
BOARD
MOUNTING
HOLES
Take note of the address you select for the RF receiver as this address must be enabled in the
system's Device Programming in the #93 Menu Mode .
Action
Mount the receiver. It must be mounted externally to the control and can detect
signals from transmitters within a nominal range of 200 feet. Take this into
consideration when determining mounting location.
Connect the receiver's wire harness to the keypad terminals (6, 7, 8, 9). Plug the
connector at the other end of the harness into the receiver.
Refer to the Installation Instructions provided with the receiver for further
installation procedures regarding antenna mounting, etc.
Set the receiver's DIP switches for an address (01-07) which is not being used by
another device (i.e., keypads, relay modules, etc.).
Note: Take note of this address setting, because you will need it when
programming the receiver into the system in Device Programming in the #93
Menu Mode.
ANTENNAS
INSERT IN
RIGHT-HAND
TERMINALS
DIP SWITCH INTERFERENCE
INDICATOR LED
DIP SWITCH #5 (PRESET ONLY ON 5881EH)
ON: SETS 5881EH FOR USE IN COMMERCIAL
FIRE APPLICATIONS (SEE THE RECEIVER'S
INSTRUCTIONS)*.
OFF: USE IN NON-COMMERCIAL FIRE
INSTALLATIONS.
* FOR COMMERCIAL FIRE APPLICATIONS
THE 5881EH PC BOARD MUST BE MOUNTED
IN A SEPARATE CABINET (SEE RECEIVER'S
INSTRUCTIONS FOR DETAILS).

Figure 8-1. 5881 RF Receiver (cover removed)

TO CONTROL'S REMOTE KEYPAD
CONNECTION POINTS. EACH RECEIVER
MUST BE ON INDIVIDUAL HOME RUN.
USE MAX. OF 220 ft. (67m0 OF #22 (0.64mm)
WIRE OR 550 ft. (168m) OF #18 (1mm) WIRE
FOR EACH RUN. 20 ft. MAX. IN COMMERCIAL
FORE INSTALLATIONS. (SEE RECEIVER'S
INSTRUCTIONS.)
YELLOW
DIP SWITCH WHIRE AREAS = SWITCH
RED
HANDLES. POSITION 2-4 DETERMINE
BLACK
RECEIVER'S ADDRESS. CONSULT
GREEN CONTROL'S INSTRUCTIONS FOR
ADDRESS TO USE. DIP SWITCH BELOW
SHOWN SET FOR ADDRESS "0."
WIRING
OPENING
PLUG & SOCKET
Section 8 – Wireless Zone Expansion
RECEIVER ADDRESS SETTINGS
SWITCH
(" - " MEANS OFF)
POSITION
0 1 2 3 4 5 6
5 PRESENT ONLY ON 5881EH (SEE TEXT AT LEFT)
ON ON ON
4
ON ON ON ON
3
ON ON ON ON
2
1
FOR FUTURE USE
7
ON
8-3