Access Control; General Information; Access Control Using Vistakey - ADEMCO VISTA-128B Installation And Setup Gude

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section

General Information

Access Control Using VistaKey

Access Control Using the PassPoint Access
Control System
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Interfacing the VISTA-128B with the PassPoint Access Control System via the Vista Gateway
U L
Module is not permissible for UL commercial burglary installations.
General Information
The VISTA-128B is capable of utilizing access control operation via one of two methods:
•
Interfacing with a VistaKey module
•
Interacting with the ADEMCO PassPoint Access Control System (PassPoint ACS) via
VISTA Gateway Module.
The VISTA-128B processes fire, burglary, arm, disarm and other information. The VistaKey
module and PassPoint ACS process card reader information and control the locking and
unlocking of doors.
DO NOT USE BOTH the VistaKey and a PassPoint Access Control System on the same alarm
panel.
Access Control Using VistaKey
The VistaKey is a single-door access control module that, when connected to the VISTA-
128B, provides access control to the protected premises. The alarm system can support up to
8 VistaKey modules (8 access points).
For detailed instructions on how to install and program the VistaKey, refer the Installation and
Setup Guide that accompanies the VistaKey-SK.
The VistaKey module contains three zones. These zones should ONLY be used for access
U L
control functions in UL installations. THESE INPUT ZONES ARE NOT TO BE USED FOR FIRE
AND BURGLARY APPLICATIONS IN UL INSTALLATIONS.
S E C T I O N

Access Control

Access Control of an Entry/Exit Point Using
VistaKey or PassPoint
Using the VISTA-128B for Stand-alone Access
Control
1 4
14-1