ADEMCO VISTA-128B Installation And Setup Gude page 121

*52 STANDARD/EXPANDED REPORT PRIMARY
Alm Rst Byp
Enter 0 for standard or 1 for expanded reporting for the primary phone number; default
is 0.
Note: Expanded overrides 4+2 format.
*53 STANDARD/EXPANDED REPORT SECONDARY
Alm Rst Byp
Enter 0 for standard or 1 for expanded reporting for the secondary phone number;
default is 0.
Note: Expanded overrides 4+2 format.
*56 USE ONLY LRR (LONG RANGE RADIO)
Enter 1 if the built-in dialer is not being used and only the LRR will be used to
communicate. Otherwise enter 0.
*57 USE LRR (LONG RANGE RADIO) IF DIALER FAILS
Enter 1 if LRR is to be used as a backup to the built-in dialer if the dialer fails. The
radio messages begin transmitting the same time as the dialer. Once the dialer receives
a kissoff, the LRR will stop transmitting no matter where it might be within its
sequence. Otherwise enter 0.
*58 LONG RANGE RADIO CENTRAL STATION #1 CATEGORY ENABLE
Alm Trbl Byp
Enter 1 to enable reports for primary Subscriber ID of Long Range Radio. Otherwise,
enter 0. Default = 0.
*59 LONG RANGE RADIO CENTRAL STATION #2 CATEGORY ENABLE
Alm Trbl Byp
Enter 1 to enable reports for secondary Subscriber ID of Long Range Radio. Otherwise,
enter 0. Default = 0.
*64 ALPHA NUMERIC PAGER INSTALLED
Enter 1 if the alpha numeric pager interface is installed. Otherwise enter 0.
*65 PAGER PHONE NUMBER FOR ALARMS
This field is used to enter the alpha numeric paging service phone number for Alarm
reports. Enter up to 17 digits, 0-9; enter #11 for *, #12 for #, and #13 for a 2-sec.
pause. Do not fill unused spaces. Enter * after the last digit of the phone number.
*66 PAGER ID NUMBER FOR ALARMS
This field is used to enter the Pager ID number for Alarm reports. Enter up to 10 digits.
If fewer than 10 digits are required, enter * after the last digit, (i.e., pager pin number).
Trbl Opn/Cls Low Batt
Trbl Opn/Cls Low Batt
Opn/Cls Syst Test
Opn/Cls Syst Test
| | | | | | | | | | | | | | | |
Section 22 – Data Field Descriptions
[0]
[0]
[0]
22-7