4285/4286 Phone Module; Installing The 4285/4286 Phone Module - ADEMCO Vista-10SEa Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section

Installing the 4285/4286 Phone Module

Programming the Control for Phone Access
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Installing the 4285/4286 Phone Module
General Information
The 4285/4286 Phone Module is an add-on accessory for the VISTA-10SEa that permits
access to the security system via a multifrequency DTMF phone (either on-premises or by off-
premises call-in).
The phone module can announce many of the same words that would normally be displayed
on an alpha keypad under the same system conditions.
• Only one phone module can be used in this security system,
• When the 4285/4286 Phone Module is in use, keypads in the system must be set to the Non-
addressable mode (address 31),
When properly connected, the 4285/4286 Phone Module will enable the user to do the
following via a multifrequency DTMF telephone:
• Receive synthesised voice messages on the phone regarding the status of the security
system.
• Arm and disarm the security system and perform most other commands using the
telephone keypad, and hear voice annunciation over the phone as confirmation after a
command is entered.
• Remotely determine the interior temperature of the protected premises (when the 4286 is
used) and set the temperature desired via a 4500 temperature control thermostat
connected to the 4286 and to the heating and air conditioning system.
The phone used for phone access must have multifrequency DTMF capability, though
multifrequency DTMF service is not necessary (if premises uses decadic PULSE dialing,
switchable phones must be set for multifrequency DTMF usage temporarily before
attempting phone access).
A Phone Access User's Guide is provided with the phone module for the user of the system.
Mounting the 4285/4286 Phone Module
The phone module may be mounted in the control cabinet if space is available or, if this is not
possible, on the side of the cabinet or adjacent to it.
When you are mounting the module outside the cabinet, use the screw holes at its rear. This
will permit it to be mounted horizontally or vertically (double-sided adhesive tape may be
used, if preferred). You can bring wires out from the side or back (a round breakout is also
available on the back).
Affix the phone module's connections label (supplied separately) to the inside of the phone
module's cover if the cover is used. If you have installed the module within the cabinet, affix
the label to the inside of the control cabinet's door.

4285/4286 Phone Module

Checking the Operation of the 4285/4286
Phone Module
S E C T I O N 8
8-1