ADEMCO VISTA-128B Installation And Setup Gude page 14

Partitioned security system with scheduling
Hide thumbs Also See for VISTA-128B:
Table of Contents

Advertisement

VISTA-128B Installation and Setup Guide
The outputs have the following characteristics:
Can be programmed to activate in response to system events
Can be programmed to activate using time intervals
Can be used for style-Y supervised bell outputs (4204CF only)
Can be activated manually using the #70 Relay Command Mode
Can be activated instantly using the #77 Command Mode
Can be supervised by control panel (zones 601-632)
1-32 can have an alpha descriptor assigned to it
Optional Vista Interactive Phone Module
Supports the ADEMCO 4285/4286 VIP Module. This permits access to the security system to
do the following:
Obtain system status information
Arm and disarm security system
Control relays
The 4285/4286 VIP Module is not Listed for use with the VISTA-128B Control Panel in a UL
U L
commercial installation.
Access Control
If programmed, provides users with a command that activates relays to open access doors
(e.g., lobby door). Each partition can be assigned to an access control relay.
By using one Vista Gateway Module (VGM), the control can be connected to the ADEMCO
PassPoint system for a fully integrated access control system.
The VistaKey module may also be used for access control. It is a single-door access control
module that, when connected to the VISTA-128B, provides access control to the protected
premises. The system can support up to 8 VistaKey modules (8 access points) and up to 250
access cards.
The access control function is not Listed for use with the VISTA-128B Control Panel in a UL
U L
commercial installation .
Optional Keyswitch
Supports the ADEMCO 4146 Keyswitch on any one of the system's 8 partitions. If used, zone
7 is no longer available as a protection zone.
Voltage Triggers
Provides a trigger connector whose pins change state for different conditions. Used with
LRR (Long Range Radio) equipment or other devices such as a remote keypad sounder,
keyswitch ARMED and READY LEDs, or a printer to print the system's event log.
1-4

Advertisement

Table of Contents
loading

Table of Contents