Automatic Tuning Into Rds Transmitters; Dx Function; Automatic Memorizing Of Transmitters (Autostore Function) - Fiat Bravo Service Manual

Electrical equipment
Radio equipment
55.
is -
1
AS
42
IS OFF
XI-98 - Update

Automatic tuning into RDS transmitters

Select the FM or A M frequency desired using
the BAND control (1).
The IS function should not be activated for
this type of selection. If the IS function is
switched on, press one of the " A " " T " but-
tons (2,3) for about 3 seconds until the mes-
sage "IS - -" and then "IS OFF" appears on
the display.
Pressing one of the "A." " T " buttons (2,3)
briefly starts the automatic search.
When an (RDS) transmitter w i t h an identifi-
cation code is found, it can be seen on the
display.

DX Function

The DX function makes it possible to choose
the sensitivity with which to search for radio
transmitters. With the DX function activated,
the radio only selects stations above a certain
power level. With the DX function deactivat-
ed, radio stations with lower power levels are
also selected. To activate the DX function,
press the button (1); the function is then de-
activated if the same button is pressed again.
Automatic memorizing
( A U T O S T O R E Function)
Select the frequency desired using the BAN D
control ( 1 ) . The message on the display w i l l
show the frequency range selected.
Press the BAN D control for about 6 seconds.
The display will show firstly the message
" A S " and then the scanning of the frequen-
cies.
When the scanning of the frequency range is
over, the six most powerful transmitters are
available w i t h the buttons (1,2,3,4,5,6).
Bravo-Brava
98 range
of transmitters
Print no. 506.670/17