Fitting And Tensioning Timing Drive Belt - Fiat Bravo Service Manual

Hide thumbs Also See for Bravo:

Table of Contents

Bravo-Brava ft™

Reverse procedure described for removal to

the point where the pressure pump is refitted.

Then refit and tension the timing belt and

auxiliary drivebelt.

Check that the timing belt and auxiliary drive-

belt do not show signs of cracking or wear

that could impair operation.

Tighten thefittings of the pipes carrying fuel

from the pressure pump to the rail to a torque

Fitting and tensioning timing drive belt

3. Secure the tool to the crankshaft drive

Fit the timing belt to the crankshaft gear

provisionally and remove the bolt indi-

cated from the oil pump.

Position tool 1860905000 on the crank-

shaft drive gear and pin (3); turn the

crankshaft through small movements until

locating dowel (2) fits into hole (4) on

the tool. In this position, cylinder no. 1 is

exactly aligned with TDC.

gear using the bolt shown.