Table of Contents
Advertisement
High Beam And Turn Signal Controls
NOTE: The headlights must be on for the high beams to
activate.
Flash-To-Pass
You can signal another vehicle with your headlights by
lightly pulling the multifunction lever toward you. This
will cause the high beam headlights to turn on, and remain
on, until the lever is released.
GETTING TO KNOW YOUR VEHICLE 55
Automatic Lighting — If Equipped
Light Sensor
The light sensor is equipped with an infrared LED, located
on the windshield. It detects changes in light intensity
outside the vehicle, based on the sensitivity of light set by
using the Menu on the display or on the Uconnect system.
The higher the sensitivity, the lesser the amount of external
light required for controlling the lighting.
Automatic Headlights
Turn the headlight switch to the AUTO position.
When the automatic headlights are enabled, the headlight
time delay is active. After the ignition switch is placed in
the STOP mode, the headlights will automatically turn off
after approximately 90 seconds depending on the settings
of the feature. The automatic headlights can also be turned
off manually by moving the headlight switch out of the
AUTO position.
The timing of the headlights is adjustable between 0, 30, 60
and 90 seconds. Refer to "Uconnect Settings" in "Multime-
dia" for further information.
NOTE: The engine must be running before the headlights
will come on in the automatic mode.
3
Advertisement
Chapters
Table of Contents
