Fiat Bravo Service Manual page 554

Hide thumbs Also See for Bravo:

Table of Contents

Gearbox and differential

Using the hydraulic jack, suitably ma-

neouvre the gearbox so that it is released

from the centering pins, then remove it

from the engine compartment slowly l o w -

ering the hydraulic jack.

Before refitting the gearbox

ential unit, it is necessary

that the thrust bearing has

in the bell housing and is not

ing with the clutch. Carry out the op-

erations described

Check that the thrust bearing is correctly

matched with the gearbox main shaft c o n -

trol lever, checking that the teeth on the

thrust bearing mesh w i t h the control lever

as shown in the diagram.

3. Fix the clutch release lever, in a fully re-

tracted position, on the bell housing, then,

using the hydraulic jack move the gearbox

- differntial unit near the clutch, centre it

on the special references and fix it to the

engine. For future operations, reverse the

order of the operations carried out for the

D R I V E S H A F T S

For the removing-refitting and the disman-

tling of the drive shafts, refer to the "Drive

shafts" paragraph for the 1370 12v version.

Removing-refitting