Fiat Bravo Service Manual page 298

Hide thumbs Also See for Bravo:

Table of Contents

Bravo-Brava i p i

discharge the fuel pressure inside the supply pipe and disconnect the pipe from the rapid connector,

following the instructions in the previous paragraphs;

attach the end of the supply pipe to the female rapid connector for the FLOWTRONIC equipment and

the male connector to the rapid connector;

position the equipment in the engine compartment, place the connecting electrical cable inside the

vehicle and connect the actual equipment as described in the instructions w h i c h come w i t h the

proceed w i t h the fuel consumption test in accordance w i t h regulation 9 3 / 1 1 6 CE and check that the

figures correspond w i t h those given in section 00 - Technical data.

1. Complete electric fuel pump

2. Fuel supply pipe

3. Female rapid connector

- carry out the fuel consumption road test in accordance w i t h directive 9 3 / 1 1 6 CE (litres per 100 km):

URBAN CYCLE - this includes a cold start, followed by a simulated urban journey;

EXTRA-URBAN CYCLE - this includes frequent acceleration, in all the gears, simulating normal out of

t o w n usage; the speed varies between 0 and 120 kph;

AVERAGE COMBINED CONSUMPTION - this involves 3 3 % of the urban cycle and 6 7 % of the ex-

tra-urban cycle;

check that the figures measured correspond to those in the section "Introduction and technical data".

Traffic conditions, driving styles, atmospheric conditions, trim levels / accessories,

roof rack is fitted, the presence of special equipment and the general state of the vehicle, can

lead to fuel consumption figures which differ from those obtained using the procedures

4. FLOWTRONIC equipment

5. Rapid connector

6. Fuel manifold