Gear Engagement Time Test - Fiat Bravo Service Manual

Bravo-Brava i p i ^

Gear engagement time test

This test is for checking the condition of clutches C2 and C3 and the brake B2, and is conducted by
measuring the time taken to engage first gear or reverse gear.
A
To obtain a reliable result, carry out several measurements
minute to pass between
To measure the gear engagement time, proceed as follows:
- apply the handbrake fully;
- start the engine, warm it up to temperature and check that the idle speed is correct;
- move the selector lever from position N to D;
- using a chronometer, measure the time elapsing between the movement of the selector lever and per-
ception of engagement of 1st gear.
N-D engagement time: less than 0.7 s
Repeat the sequence of operations, except moving the selector lever from position N to R.
N-R engagement time: less than 1.2 s
Engagement time
Higher than specified value from N to D
Higher than specified value from N to R
Copyright Fiat Auto
Auto transmission and differential
two consecutive measurements.
Description and operation
and take the average value. Allow
Possible causes
* Insufficient line pressure
* Clutches C1 and C3 slipping
* Incorrect operation of
free wheel F1
* Insufficientn line pressure
* Clutch C2 slipping
* Clutch C3 slipping
* Brake B2 slipping
21-27.
one
P4A35AB01
35