Table of Contents
Advertisement
EXTERIOR LIGHTS
Headlights
The headlight switch is located on the left side
of the instrument panel. The headlight switch
controls the operation of the headlights,
parking lights, daytime running lights, fog lights
and the dimming of the instrument cluster and
interior lighting.
Headlight Switch
Turning on the headlights will illuminate the
instrument cluster and the controls located on
the instrument panel.
Daytime Running Lights (DRLs) — If
Equipped
The Daytime Running Lights (DRLs), if enabled
by the Uconnect settings, will turn on when the
ignition is placed in the ON/RUN position and
the park brake is not applied.
The DRLs will be disabled during turn signal
operation and resume operation when the turn
signal operation has ended.
High Beams
To turn on the high beam headlights, push the turn
signal lever forward (toward the front of the vehicle)
and an indicator will illuminate in the cluster. To turn
off the high beams, pull the turn signal lever rear-
ward (toward the rear of the vehicle).
High Beam And Turn Signal Controls
GETTING TO KNOW YOUR VEHICLE
NOTE:
The headlights must be on for the high beams to
activate.
Flash-To-Pass
You can signal another vehicle with your head-
lights by lightly pulling the multifunction lever
toward you. This will cause the high beam head-
lights to turn on, and remain on, until the lever
is released.
Automatic Lighting — If Equipped
Light Sensor
The light sensor is equipped with an infrared
LED, located on the windshield. It detects
changes in light intensity outside the vehicle,
based on the sensitivity of light set by using the
Menu on the display or on the Uconnect system.
The higher the sensitivity, the lesser the amount
of external light required for controlling the
lighting.
35
2
Advertisement
Table of Contents
