Fiat Bravo Service Manual page 797

Hide thumbs Also See for Bravo:

Table of Contents

1 . Remove the trim shown in the figure by

undoing the retaining bolts and releasing

the diesel lines from the retaining clip.

2. Remove the bolt retaining the bracket

joining the fuel lines.

3. Disconnect the connector of the brake and

clutch fluid level sensor, then remove the

stud retaining the lining of the bulkhead be-

tween engine bay and cabin, and move the

lining to one side.

4. Unscrew the bolts retaining the diesel filter

bracket, disconnect the connections shown

and position the bracket to one side.

5. Move the lining of the bulkhead between

engine bay and cabin further to one side,

then unscrew the nut retaining the accele-

rator cable to the bulkhead, remove the

underlying rubber guide and withdraw the

accelerator cable.

Publication no. 506.876