Bravo-Brava @ i
Copyright Fiat Auto
12v
Braking system
Hydraulic operation
B R A K E - C L U T C H FLUID R E S E R V O I R
Checking low brake fluid warning light
NOTE At intervals, check warning light opera-
tion by pressing down on the top edge of
the reservoir cover (arrowed). The brake
system warning light should come on
when the ignition is turned to MAR.
Removing-refitting
Proceed as follows to remove the brake fluid
reservoir:
1. Disconnect the connector of the fluid level
sensor and remove the reservoir cap, then
drain the brake fluid from the reservoir us-
ing a syringe.
2. Disconnect both brake pipes and the hy-
draulic clutch pipe from the reservoir.
3. Unscrew the bolt retaining the reservoir to
the body and remove from the vehicle.
Take care the fluid remaining in the
reservoir does not leak out.
NOTE
Carry out removal operations in reverse
order to refit the brake and clutch reser-
voir.
A
Before filling the tank, ensure it is ex-
tremely clean.
Bleeding hyrdaulic brake and clutch
system
3 3 .
P4A23DA04
3