Removing-Refitting Gear Change Con- Trol Unit (Control Module) - Fiat Bravo Service Manual

Auto transmission and differential
Servicing and adjustments
21-27.
48
Finish refitting the selector lever position
<i>
sensor by reversing the procedure for re-
moval. Finally carry out the following checks:
- the engine must only start with the selector
lever in position P or N;
- each position of the selector lever must be ac-
companied by the relevant indications on the in-
dicator panel and instrument panel display.
R E M O V I N G - R E F I T T I N G GEAR C H A N G E
C O N T R O L UNIT (CONTROL M O D U L E )
The gear change control unit is located under
the rear seat cushion, on the right. Before
proceeding with removal, disconnect the
battery's negative pole, then:
1. Remove the rear seat cushion by undoing
the bolts securing the retaining brackets to
the body shell.
2. Lift the trim under the rear seat cushion,
then remove the bolts and nut securing
the control unit mounting bracket to the
body shell.
3. Rotate the control unit mounting bracket,
disconnect the supply wiring, then undo
the nuts securing the control unit to the
bracket.
W A R N I N G S
- Handle the control unit carefully to avoid
any impact.
- Do not remove the control unit cover or try
to dismantle it.
- Do not touch the connector pins directly.
- Insert the connector
unit until it clicks.
Bravo-Brava
fully into the
Publication no. 506.670/06
ft**
control