Fiat Bravo Service Manual page 829

Hide thumbs Also See for Bravo:

Table of Contents

Braking system

Hydraulic operation

1. Release the EG R control unit wiring bundle

from the clips shown.

2. Move the lining of the bulkhead between

engine bay and cabin further to one side,

then disconnect the vacuum inlet pipe

from the brake servo.

3. Undo nuts securing the brake pump to the

brake servo, then take the pump out

slightly without disconnecting the brake

Bravo-Brava 1 0

Continue by removing parts from in-

side the car and then removing the

brake servo as described for the 1370

12v version. Note that the air line

shown in the figure alongside must

also be disconnected for the

Publication no. 508.876