Engine Idle Adjustment Actuator/Throttle Position Sensor Removing-Refitting; Accelerator Control Cable Removing-Refitting - Fiat Bravo Service Manual

Hide thumbs Also See for Bravo:

Table of Contents

Removing-refitting

Disconnect the accelerator cable as f o l l o w s :

- w o r k i n g from inside the vehicle ( A ) , d i s c o n -

nect the control cable from its anchorage o n

accelerator pedal ( B ) ;

- turn the accelerator lever t o disengage the

bracket (D) and move the accelerator cable

Reverse removal instructions t o refit.

T O R / T H R O T T L E POSITION S E N S O R

NOTE The engine idle adjustment actua-

Removing-refitting

To remove the actuator, disconnect the c o n -

nector and unscrew the retaining bolts

r o w e d ) .

NOTE It is compulsory to zero and self-learn

9:^-ltb.!teas-andiir^taces

cable terminal

A D J U S T M E N T

tor/throttle position sensor should be

disconnected from the throttle body

only in case of replacement_because

removing I refitting causes damage to

sealing rings) and correct component

operation cannot be guaranteed once

the component is refitted.

data as described in the

"THROTTLE BODY" paragraph.