Fiat Bravo Service Manual page 473

Hide thumbs Also See for Bravo:

Table of Contents

Bravo-Brava ft 1 *

- disconnect the fuel delivery pipe from the quick-fit connector located against the rear wall of the en-

gine compartment and, using the connectors of the test equipment 1860955000, make the connec-

tions to the Flowtronic device (1806149001) as follows:

1. Cut and withdraw the end (A) of the connector ( 2 ) , then connect the end (B) to the connector of

the rigid pipe (3) and the end (A) to the inlet pipe into the Flowtronic ( 4 ) .

2. Insert the connector (5) into a piece of pipe (6) and lock it w i t h a metal clip, then connect the end

(A) to the pipe (1) previously disconnected and the end (B) to the outlet pipe from the Flowtronic

device ( 4 ) .

- carry out a fuel consumption road test in accordance w i t h the Directive 93/116/CE (litres x 100 km):

URBAN CYCLE - includes one cold start, followed by a simulated varied urban journey.

OUT-OF-TOWN CYCLE - includes frequent accelerations, in all gears, simulating normal out-of-

t o w n use of the vehicle; the speed varies between 0 and 120 k m / h .

AVERAGE COMBINED CONSUMPTION - includes 37% urban cycle and 63% o u t - o f - t o w n cycle.

The type of journey, traffic situations, style of driving, weather conditions, level of

tras/accessories, presence of roof rack, presence of special equipment and the general condi-

tion of the vehicle can lead to different fuel consumption values from those measured by the

above-mentioned

- check that the values measured correspond to those given in the "Introduction and technical data"

fittings/ex-