Removing-Refitting Servo Brake - Fiat Bravo Service Manual

Braking system
Hydraulic operation
3 3 .
6
R E M O V I N G - R E F I T T I N G S E R V O B R A K E
. mA
1 . Working from the engine bay, remove the
2. Remove the protective relay cover located
3. Remove the relay bracket by undoing the
4. Remove the retaining stud and move the
5. Undo both nuts retaining the brake pump
P4A02DA01
Bravo-Brava $
On right hand
brake servo is positioned inside the
cabin under the pedal unit. To take
out, remove the facia trim as de-
scribed in Section
as follows.
sleeve connecting air cleaner and butter-
fly valve case.
otHaulkhealotetwee«ngirtBae^^
bolt indicated.
bolts retaining it to the body, disconnect
connector indicated and move the bracket
to one side.
lining of the bulkhead between engine
bay and cabin
side.
to the brake servo.
12v
P4A01 DA04
drive vehicles, the
70, then proceed
to one
Publication no. 508.876