Replacing Auxiliary Belt; Removing-Refitting Alternator Drive Belt And Power Steering Pump - Fiat Bravo Service Manual

Engine

Replacing auxiliary belt

10.
- Take great care not to damage individual components when the power unit is fitted
- When fitting the coo/ant lines, align groove on rubber hose with ridge on associated rigid
sleeve. When filling the cooling system, refer to section on "Removing-refitting radiator".
Ensure that the power unit mounting points are properly secured.
Clutch pedal height.
12
Bravo-Brava
R E M O V I N G - R E F I T T I N G A L T E R N A T O R
D R I V E B E L T AND
PUMP
Removing
Position the vehicle on a lift, remove the right
front wheel, disconnect the battery negative
terminal and then proceed as follows.
Remove the wheel arch guard by u n -
screwing the retaining bolts shown. Use
tool 1870077000 to prise up the stud
shown.
2. Turn the tensioning device in the arrowed
direction and release belt tension before
removing.
A
Check the condition of the drive belt.
In particular, check for cracks, tears,
surface wear (smooth or shiny in ap-
pearance) and dry or hard parts with
consequent loss of grip. Replace belt
if even one of the above defects is
present.
0
TD100
POWER S T E E R I N G
Publication no. 506.670/08