Check/Adjust Handbrake Lever Travel; Check/Adjust Tappet Clearance - Fiat Bravo Service Manual

Introduction
Planned maintenance
00.
8
n
Operate the handbrake lever several times
and check that the travel of the toothed sec-
tor is 5 notches.
If this is not the case, proceed w i t h the ad-
justment as follows:
- remove the protective boot for the control
lever;
- act on the adjustment nut shown, tighten-
ing or loosening it in order to increase or
decrease the handbrake lever cable travel;
- check that the lever travel is equal to 5
notches on the toothed sector.
A
mm
The following components must be removed
in order to check and, if necessary, adjust the
tappet clearance.
Bravo-Brava 1910 TD
1. Remove the upper engine protection.
P4A08CA03
Bravo-Brava
C H E C K / A D J U S T HANDBRAKE L E V E R
T R A V E L
When the adjustment has been car-
ried out, the control
should not exceed 5 notches on the
toothed sector.
With the handbrake lever in the rest
position the rear wheels should rotate
freely; if this is not the case, repeat
the adjustment.
C H E C K / A D J U S T T A P P E T CLEAR¬
ANCE
lever travel
Print no. 506.670/09