Removing The Test Equipment; Checking Fuel Consumption Using Flowtronic Equipment 1866149001 - Fiat Bravo Service Manual

Hide thumbs Also See for Bravo:

Table of Contents

Removing the test equipment

Remove the test equipment 1860955000 with the key in the OFF position, following these instructions:

- introduce the end of the pipe connected to the valve (c) into a suitable container;

- open the valve (c) and drain the excess fuel into the container;

- keep the pipe in the container and disconnect the end of the supply pipe from the female connector for

the adaptor (A) keeping the connection upwards;

- let the fuel in the pipes f l o w into the container;

- disconnect the end of the adaptor (B) from the rapid connector and let the residual fuel f l o w from the

pipes into the container;

- reconnect the fuel supply pipe.

Checking fuel consumption using

F L O W T R O N I C equipment 1866149001

To carry out the check, the equipment should

be configured with the connectors shown in

the diagrams:

A. supply pipe side

B. fuel manifold side

If this has not been done, make the adjust-

ment following the instructions given below:

- cut the end of the FLOWTRONIC equip-

ment inlet pipe and replace it w i t h a female

rapid connector ( 1 ) , contained in the Kit

No. 1860955003, as illustrated in figure A;

cut the end of the FLOWTRONIC equip-

ment outlet pipe and replace it w i t h a male

connector (2), contained in the Kit No.

1860955003, as illustrated in figure B.

The connectors removed should be

recovered and kept for any future

connections.