Auto Cycle - Gestetner CP6244 Operating Instructions Manual

Operation

Auto Cycle

Use this function to process masters
and make prints in a single operation.
1
Note
❒ The default is On.
❒ You can specify whether Auto Cy-
cle mode is enabled or not when
the power is turned on. See "1
Auto Cycle ON/OFF" on p.75 "4
Mode Setting".
A A A A
If Auto Cycle is Off, press the { { { { Au-
to Cycle} } } } key to enable it.
B B B B
Set the original and enter the
number of prints.
C C C C
Press the { { { { Start} } } } key.
Printing starts immediately after
the master is made.
34
ZLKS035N
ZLKS030N