Auto Cycle - Gestetner CP6244 Operating Instructions Manual

Operation

Auto Cycle

Use this function to process masters
and make prints in a single operation.
1
Note
❒ The default is On.
❒ You can specify whether Auto Cy-
cle mode is enabled or not when
the power is turned on. See "1
Auto Cycle ON/OFF" on p.79 "4
Mode Setting".
A
If Auto Cycle is Off, press the {Au-
to Cycle} key to enable it.
B
Set the original and enter the num-
ber of prints.
C
Press the {Master Making} key.
Printing starts immediately after
the master is made.
38
AQN030S
AQN024S