Error & Status Messages on the Display
Panel
Messages/Second messages
Cannot detect selected paper
size. Set ### paper, then
press [OK].
Controller Communication
Error
Controller Error
Making Master...
NVRAM Error.
Parallel Interface Error.
Printing
<Type A only>
"Print is not finished."
"Press [fin PRNT] for next
mstr makg."
(These messages appear al-
ternatively.)
4. Troubleshooting
Descriptions and Solutions
Printing on paper with a size undetectable by the machine has
been requested.
Set an appropriate amount of paper in the Paper Feed Tray, and
then press [OK] (When using Type B, press the { { { { OK} } } } key). Incon-
sistencies in the size of paper from the Paper Feed Tray will be
ignored and printing will be performed. Press [Job Reset] to stop
printing.
Note
"###" in the message represents a paper size.
The communication between the controller and the engine is ab-
normal.
First turn the power switch off and then on. If the message ap-
pears again, consult your sales or service representative.
The ROM is faulty.
First turn the power switch off and then on. If the message ap-
pears again, consult your sales or service representative.
The master is being made.
An error has occurred in the Memory Unit.
First turn the power switch off and then on. If the message ap-
pears again, consult your sales or service representative.
The parallel interface is abnormal.
Consult your sales or service representative when using the par-
allel interface.
Data is being printed.
Wait until the job is finished.
Printing is not finished.
Printing has been interrupted. Perform one of the following
procedures:
• Press the { { { { Print} } } } key, and printing will restart. Before the
print amount display reaches 0, press the { { { { Print} } } } key to print.
• Press [fin PRNT], and printing will stop. The interrupted
prints will not be performed.
33