Gestetner CP6244 Operating Instructions Manual page 250

Appendix
E E E E
Select [Property Sheet], and then click [OK].
TCP/IP
A Click the [General] tab, and then type the device name into the [Device
Name] box and a comment into the [Comment] box.
• In the [Device Name] box, type the name of the printer using less than 13
characters. The factory default name consists of "RNP" and the last 3
bytes of the MAC address on the Network Interface Board. For example,
when the MAC address is 00:00:74:62:7D:D5, the factory default name is
"RNP627DD5". No name of 9 characters is permitted if the prefix is
"RNP". Also, when DHCP is selected as an IP address setting, the
number of characters is limited to 13 characters.
• In the [Comment] box, type a comment about the printer using less than
31 characters.
NetBEUI
A Click the [General] tab, and then type a comment into the [Comment] box.
In the [Comment] box, type a comment about the printer using less than 31
characters.
B Click the [NetBEUI] tab.
7
C Type the computer name into the [Computer Name] box.
• In the [Computer Name] box, type a name that helps you to identify a
printer using the NetBEUI protocol. The factory default name consists
of "RNP" and the last 3 bytes of the MAC address on the Network In-
t e r f a c e B o a r d . F o r e x a m p l e , w h e n t h e M A C a d d r e s s i s
00:00:74:62:7D:D5, the factory default name is "RNP627DD5". A maxi-
mum of 13 characters consisting of uppercase English letters, numbers,
or symbols (except "*+,/:;<=>?[\]|. and space) can be used. No name is
permitted if the prefix is "RNP". You must avoid using a name already
used.
• In the [Comment] box, type a comment about the printer using less than
31 characters.
F F F F
Click [OK].
The NIB Setup Tool closes, and the settings are transmitted to the printer.
G G G G
Exit SmartDeviceMonitor for Admin.
86