Getting Started
Connecting the Machine to the Host Using the Parallel Cable
Connect the machine to the host computer using a parallel cable compliant with
IEEE 1284 (available separately).
1
Follow these steps to connect the machine to the host computer.
Important
❒ Before connecting an interface cable between the machine and a computer,
make sure that the machine is not operating, and then turn off the main power
switches of the machine and the computer.
❒ Be sure to use the designated interface cable. Using another cable may cause
radio interference.
A A A A
Plug the 36-pin end of the parallel cable into the parallel port at the right
side on the back of the machine.
B B B B
Squeeze the wire clips on each side of the connector together until they
snap into place. The clips hold the cable securely in place.
❖ ❖ ❖ ❖ Type A
❖ ❖ ❖ ❖ Type B
C C C C
Plug the other end of the parallel cable into the computer's parallel port.
If there are the wire clips, squeeze them on each side of the connector to-
gether.
20
ZJXH160J