Gestetner CP6244 Operating Instructions Manual page 223

O O O O
Press the { { { { ESC} } } } key until "EXIT?" appears, and select [Yes] to exit PCON-
SOLE.
Note
To make sure that the machine is correctly configured, type the following
from the command prompt.
F:> USERLIST
If the machine works as configured, the name of the print server appears
as an attached user.
Setting Up as a Remote Printer
A A A A
Log on to the file server as a Supervisor or a Supervisor equivalent.
B B B B
Run the NIB Setup Tool.
Reference
p.52 "Running the NIB Setup Tool"
C C C C
Click [Property Sheet] and click [OK].
The [NIB Setup Tool - Network board list] dialog box of the Network Interface
Board appears.
D D D D
Click [IPX protocol].
E E E E
Click the IPX address of the Network Interface Board to be configured, and
click [Next >].
Note
If you do not know which Network Interface Board you are configuring,
see the system configuration list to check the MAC address (Network Ad-
dress).
F F F F
Make sure that the MAC address and IPX address are correct, and click [Fin-
ish].
The [NIB Setup Tool] window appears.
G G G G
Click [Configure].
The property sheet appears.
H H H H
Click the [General] tab, and type the name of the print server into the [Device
Name] box.
NetWare 3.x - Advanced Settings
5
59