Monitoring and Configuring the Printer
Changing Names and Comments
You can change printer names and make comments for printers to easily identify
the printers listed on SmartDeviceMonitor for Client.
The following utilities are used to change printer names and comments.
SmartDeviceMonitor for Admin
Allows you to change names and comments when the TCP/IP protocol or
IPX/SPX protocol is available. You can install SmartDeviceMonitor for Ad-
min from the CD-ROM that comes with the printer. For more information
about installing SmartDeviceMonitor for Admin, see Setup Guide.
Web Browser
Allows you to change names and comments when the TCP/IP protocol is
available.
Note
Each of the names, one for the TCP/IP protocol form (printer name) and
NetBEUI protocol form, is changed individually. However comments are
common to both of them.
The factory default name consists of "RNP" and the last 3 bytes of the
MAC address on the Network Interface Board. For example, when the
MAC address is 00:00:74:62:7D:D5, the factory default name is
"RNP627DD5". Comments are not configured.
SmartDeviceMonitor for Admin
A A A A
Run SmartDeviceMonitor for Admin.
B B B B
Click the [Group] menu, point to [Open LAN], and select [TCP/IP] or [IPX/SPX].
A list of printers appears.
Note
Select the protocol of the printer for which you want to change the config-
uration.
C C C C
On the list, select a printer whose Network Interface Board configuration
you want to change.
D D D D
From the [Tools] menu, select [NIB Setup Tool].
The NIB Setup Tool starts up.
Monitoring and Configuring the Printer
7
85