Postscript Printing From Windows; Netware Printing - Gestetner CP6244 Operating Instructions Manual

Appendix

PostScript Printing from Windows

When printing PostScript from Windows, see Printer Reference 2 for how to con-
figure the Network Interface Board and printer driver.

NetWare Printing

Form Feed
You should not configure the form feed on NetWare. The form feed is controlled
by the printer driver on Windows. If the NetWare form feed is configured, the
machine might not print properly. If you want to change the form feed setting,
always configure it on Windows.
• With Windows 95/98/Me, clear the [Form feed] check box on the [Printer Set-
tings] tab in the [Printer Properties] dialog box.
• With Windows 2000, clear the [Form feed] check box on the [Netware Settings]
tab in the [Printer Properties] dialog box.
• With Windows NT 4.0, clear the [Form feed] check box on the [Netware Settings]
tab in the [Printer Properties] dialog box.
7 Banner Page
You should not configure a banner page on NetWare. If you want to change the
banner page setting, always configure it on Windows.
• With Windows 95/98/Me, clear the [Enable banner] check box on the [Printer
Settings] tab in the [Printer Properties] dialog box.
• With Windows 2000, clear the [Enable banner] check box on the [Netware Set-
tings] tab in the [Printer Properties] dialog box.
• With Windows NT 4.0, clear the [Enable banner] check box on the [Netware Set-
tings] tab in the [Printer Properties] dialog box.
Printing after resetting the machine
After resetting the remote printer, it will be cut off from the print server for about
30-40 seconds before connecting again. Due to the NetWare specification, print
jobs may be accepted, but they will not be printed during this interval.
When using the machine as a remote printer, wait about 2 minutes after resetting
the machine before attempting to print.
114