Gestetner CP6244 Operating Instructions Manual page 265

AutoNet
Use the set command to configure AutoNet.
Reference
For more information about AutoNet, see p.118 "Using AutoNet".
msh> set autonet {on|off}
•"on" means active and "off" means inactive.
Changing the password
Use the passwd command to change the remote maintenance password.
Important
Be sure not to forget or lose the password.
Note
The default factory password is "password".
A A A A
Type "passwd".
msh> passwd
B B B B
Type the current password.
Old password:
C C C C
Type the new password.
New password:
Note
The password must consist of 3 to 8 alphanumeric characters and symbols.
Upper and lower case characters are considered unique. For example, R is
different from r.
The password is the same as that used in the configuration of the Network
Interface Board using a Web Browser and that used in the NIB Setup Tool.
If you change a password from telnet, the other passwords are also
changed.
D D D D
Type the new password once again.
Retype new password:
Remote Maintenance by telnet (mshell)
7
101